K9AY fixed Rload version 2.3

This revision is from 2019/02/02 21:03. You can Restore it.

Current version 2.3(Edit)

Assembled KIT(Edit)

All parts you need - KIT(Edit)

The drill drawing(Edit)

Paste the drawing on the box and fix it with some tape.

Schematic diagram(Edit)

- version 2.3

Insert rest parts(Edit)

chooce the control way...(Edit)

- By the jumper JP2 you can select controlling over coax or DC voltage on connector X3

TRANSFORMERS winding - very important thing!(Edit)

    • for 50 ohm coax feed line : 2 turns on primar (coax) and 6 turns on secondar side (loop)
    • for 75 ohm coax feed line : 2 turns on primar (coax) and 5 turns on secondar side (loop)

- In version 2.3 and higher, you can select Coax impedance by jumper JP3.

- Transformer should have 5 + 1 turns.

Common-mode coax choke(Edit)

- choke measurements

Wind the coax(Edit)

- Wind the coax as is on the picture, there should be 7 or 8 turns.

- fix it by one binder and use second one to fix choke to the PCB

Solder the coax (Edit)

KIT - all parts assembled.(Edit)

Example of controller.(Edit)

- Injector to coax line:

- direction controller

K9AY loops design example.(Edit)