usb_rotator_interface_4
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
usb_rotator_interface_4 [2022/02/05 19:24] ok1hra [Some tips] |
usb_rotator_interface_4 [2022/02/17 23:23] (current) ok1hra [Connect Azimuth cw/ccw pulse] |
||
|---|---|---|---|
| Line 216: | Line 216: | ||
| - **P5 jumper switch to enable.** | - **P5 jumper switch to enable.** | ||
| - Input must grounded to **digital GND**. | - Input must grounded to **digital GND**. | ||
| - | - Next step test with [[usb_rotator_interface_4# | + | - Next step test with [[usb_rotator_interface_4# |
| + | - Note: [[https:// | ||
| ---- | ---- | ||
usb_rotator_interface_4.1644085477.txt.gz · Last modified: 2022/02/05 19:24 by ok1hra
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
