User Tools

Site Tools


usb_rotator_interface_4

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
usb_rotator_interface_4 [2022/02/05 19:24]
ok1hra [Some tips]
usb_rotator_interface_4 [2022/02/17 23:23] (current)
ok1hra [Connect Azimuth cw/ccw pulse]
Line 216: Line 216:
   - **P5 jumper switch to enable.**   - **P5 jumper switch to enable.**
   - Input must grounded to **digital GND**.   - Input must grounded to **digital GND**.
-  - Next step test with [[usb_rotator_interface_4#install_test_firmware|test firmware]].\\+  - Next step test with [[usb_rotator_interface_4#install_test_firmware|test firmware]]
 +  - Note: [[https://remoteqth.com/w/doku.php?id=usb_rotator_interface_4#firmware|K3NG firmware]] use only pin12. \\
  
 ---- ----
usb_rotator_interface_4.txt · Last modified: 2022/02/17 23:23 by ok1hra